Kenwood TH-26A User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Pressing the F key for longer than 1 second and then
pressing the VFO key will initiate VFO or Memory scan.
Pressing the key after scan has been initiated will cause
scan to stop.
If you press and hold the VFO key while you turn on the
POWER switch you will reset the microprocessor’s VFO
memory,
without
destroying
the
memory
channel
or
call channel data.
(DMR key
This key is used to the select MR (Memory Recall) mode
from the VFO mode. The Tuning control can then be
used to select the desired memory channel.
Press and hold the key for longer than 1 second to
initiate
memory
channel
scan.
Pressing
the
key
after
scan has been initiated will cause scan to stop.
Pressing the key within 10 seconds of pressing the F key
will store the displayed data into memory.
In the memory channel mode pressing the F key for
longer than 1 second and then pressing the MR key will
cause
the
memory
channel
to
be
skipped
during
memory channel scan.
If you press and hold this key while you turn on the
POWER switch you will clear all the memory channels.
0CALL key
Press this key to activate the call channel function.
Press and hold the key for longer than 1 second to
initiate call channel scan. Pressing the key after scan has
been initiated will cause scan to stop.
Pressing the key within 10 seconds of pressing the F key
will store the displayed data into call channel.
Pressing the F key for longer than 1 second and then
pressing the CALL key will initiate V / M / C scan. See
section
4-5-9
for
additional
information
on
this
function. Pressing the key after scan has been initiated
will cause scan to stop.
If you press and hold this key while you turn on the
POWER switch you will be able to turn the AUTOMATIC
POWER OFF function ON or OFF.
(DON AIR indicator
ON whenever the transceiver is in the transmit mode.
(DT.ALT key
This key is used to activate the Tone Alert function.
Pressing the key within 10 seconds of pressing the F key
will turn the BEEP function OFF or ON.
Pressing the F key for longer than 1 second and then
pressing the T.ALT key will cause radio to toggle the
hold / resume mode between Time Operated scan and
Carrier Operated scan.
13