Kenwood TH-26A - Manual (Page 40)

2. Select the first digit by
rotating the Tuning control.
3. Press the SHIFT key. The first
digit is registered and the
second digit begins to flash.
4. Select the second digit by
rotating the Tuning control.
5. Press the SHIFT key. The
second digit is registered
and the third digit begins to
flash.
6. Select the third digit by
rotating the Tuning control.
7. Press the SHIFT key and the
complete DTSS code is
registered. The mode returns
to the previous one.
SHIFT
Notes
1. If a key other than the SHIFT key is pressed dur­
ing operation, code selection mode is canceled.
2. If no action is taken for longer than 10 seconds,
code selection mode is automatically cancelled.
OSelecting using memory channels 1 through 3
1. Follow steps 1 through 7 above In the VFO mode.
2. Store the selected code in memory.
Follow steps 1 through 7 in memory mode to edit a
stored code.
• Selecting and storing a code with the DTMF KEY PAD
(DTP-1)
A DTSS code can be selected and stored as follows when
the DTMF KEY PAD (option) is operational.
1. Press the F key for longer than 1 second. Press the
SHIFT key while the F indicator is flashing (for 10
seconds).
2. Then enter a three-digit number on the key pad.
• Using the DTSS function
1. Adjust the SQL control to the
threshold point.
2. Press the F key. Press the
SHIF key while the F
indicator is flashing (for 10
seconds). The DTSS indicator
begins to light.
3. Squelch will open when the
proper code is received.
4. When the PTT switch is
pressed, the code shown in
0 SHIFT
40