2. dtu-1 dtmf unit installation – Kenwood TH-26A User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7-2. DTU-1 DTMF UNIT INSTALLATION
Note
Be
sure
to
turn
the
POWER
switch
OFF
before
removing the battery case.
2
.
Attach
the adhesive sheet
supplied with the DTU-1 to
the front (connector side) of the unit. (Fig.1)
Detach the battery case and remove the two screws
on
the
front
panel
which
are
used
to
hold
the
terminal plate on the bottom of the unit. (Fig.2)
Remove the three screws that hold the front panel.
(Fig.2)
A flat
cable is attached
to the inside of
the front
panel.
Detach the front
panel paying attention to
the wiring. (Fig.3)
Remove the backing paper from the adhesive sheet
attached to the DTU-1 and fit the connector. (Fig.3)
6. Attach
the front panel being careful not
to pinch the
flat cable.
7. Tighten the three screws on the front panel.
8. Tighten the two screws on the bottom of the unit.
5.
45