Kenwood TH-26A User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
the
figure
is
sent
out
for
about 0.5 second.
PTT ON
T
PTT OFF
T
m
Code (Approx.
0.5 seconds)
Notes
1. Voice output is muted during code output.
2. We recommend that you turn off the battery
saver function when you use the DTSS function.
5. To cancel the DTSS function press the F key again and
then press the SHIFT key.
• Delay during DTSS output
A delay is built in when the DTSS is sent out.
Normal
250 mS
SHIFT
450 mS or 750 mS
To change delay time press the F key for
second and press the REV key while the
flashing within the 10 seconds.
more than 1
F indicator is
• Using DTSS with a repeater
The DTSS signal is transmitted after a short delay If the
PTT switch is pressed while the — indicator or the +
indicator is lit. This is to avoid any malfunction due to
the
DTSS
signal
being
interrupted
by
repeaters
with
long response times.
PTT ON
T
PTT OFF
T
----- Code (250mS)
------- Delay time (450mS or 750mS)
The delay time is set at 450 mS (initial state), but can be
changed to 750 mS.
41