Kenmore 808353 User Manual
Page 92
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PROBLEM
POSSIBLE CAUSE
ACTION
Noisy Pump system.
1.
Debris in tub bottom.
1.
Cleon out pump.
2,
Pump part or parts not tightened down
property
2.
Inspect and correct..
3.
Impellers improperly shimmed and
3.
Use Shirn gauge furnished with impeller
rubbing.
and seal kit. When seals are shimmed
correctly the impetlers will be in
correct position.
4.
Defective bearings in motor.,
4„
Remove all impellers and test run
motor.
5.
Sucking sound at end of drain period.
5.
Normal condition.
Main motor kicks out
repeatedly on
1.
Debris in pump, locking pump system.
1.
Clean pump.
overload.
2
Motor shaft seats are
stuck
together
2
Disassemble and inspect seals
3.
Main motor shaft not centered in
3.
Use installation tool No, 803923
pump housing cavity.
(available through Sears parts
department) and center housing as
outlined.
4,
Main motor bolts not tightened
4,
Loosen bolts and tighten evenly
evenly.
(tighten crosswise).
Dishwasher will not
heat water to
1.
Defective heating eiement.
1.
Check contirtuity.
required temperature
2.
Open circuit through timer safety
2.
Refer to wiring diagram ar>d trace
in the thermostat
thermostat and/or heater.
circuits for voltage loss.
delay periods-
3.
Defective thermostat.
3.
Refer to the proper section in this
manual for testing thermostat,
Dishes are not dry at
1.
Open circuit through timer to heater,.
Ì,
Refer to wiring diagram and trace
end of dry phase.
circuit for loss of voltage.
2
Defective heater.
2.
If voltage to heater, remove leads and
check for continuity through heater.
3,
improper loading of dishes.
3.
Refer to Owner's Manual for proper
loading pattern.
4,
Water not hot enough,
4.
Refer to detergent manufacturers
recommendation. Check and adjust
water heater
5.
Blower inoperative.
5,
Check operation of the blower motor in
(Blower models only.)
the dry phase after the final pump out.
6.
Unfavorable temperature and humidity
6.
Unlatch door at end of final rinse, and
conditions,, (Non-blower models,!
allow dinnerware to cool before
removing from dishwasher. Moisture
--------- -------
:
-------
—
---------------------------------------------- ------------------------ ----- —----------------------------------------------------------------------- —
will evaporate.
8 9