Figure 60 – Kenmore 808353 User Manual
Page 55
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
If the second wash or'final rinse phase Is prolonged for an excessive amount of time, causing the water to become
hotter than necessary:
1, Check for too high calibration. (Follow same procedure as outlined on the previous page )
2, Check the thermostat circuit for correct wiring
3
Check to see that power is applied to one terminal of thermostat by the timer at the proper time.
4. Check the heating eiemertt
If 1 and 2 are satisfactory, a faulty thermostat is indicated and should be replaced.
CAUTION:
Care should be taken when installing a replacement thermostat so as not to place a ny
strain or pressure on the body of the thermostat. Note that the thermostat ts held m
position by a clamp on the wire leads.
c
V
nichufatheri hnth
nortable
and built-in are
eauipped
with sensing devices to Indicate to the user
Some Kenmore Dishwashers, both portaoie ana ouni m,
^
^ "Cool."
the temperature of the water withm the machine. The water temperature will iaii witnm me ranges
ut
.
"Normal," or "Sanl" and will be indicated by lights on the console as shown m Figure 59.
TEMPERATURE INDICATOR LIGHT
■CYCLE
indicator
LENS
-SAN!
NORMAL
COOL
DRY TIME SELECTOR TJEMPERATURE DELAY
F I G U R E 5 9
....
The "coot" ihermoslat (Figure 60)is a single pole single throw temperature controlled switch The "sam” thermostat
(Figure
61
) is a single pole double throw switch.
FIGURE 60
52