Center motor shaft with pump housing – Kenmore 808353 User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CENTER MOTOR SHAFT WITH PUMP HOUSING
RAISE ED13ES OF
basket
to
allow
OAU0E TO SEAT ON
P
ump
mousinq
SURFACE
10 Before replacing the required shims and lower impeller on the motor shaft, carefully examine the mating sur
faces of the lower impeller shaft seal ¡while ceramic) and the pump housing seal ¡black carbon) These sunaces
should be perfectly smooth and polished In appearance If either appears scratched, pitied or damaged in any
fashion, the seal must be replaced otherwise a leak may occur
Clean seal cavity thoroughly Install the lower seal. Use service tool 803923
11, Fasten motor pump housing assembly to tub Be sure casting is dean and a new gasket is used.
12
. Re-assemble remaining pump components in reverse order of removal
IMPORTANT;
Be sure the relay furnished In the kit is used with the replacement motor, otherwise, serious
damage to the motor can result! Carefully review the instructions packed with the motor
3 9