Figure 42, Hoses and couplers – Kenmore 808353 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hoses and Couplers
A
Front Opening Portables
Proper routing of hoses for Front Opening Porlabies is shown in Figure 42 Tub removal is not required to perform
the following operations
FIGURE 42
jsjOTEiTub is removed only to
show
location and routing of hoses
To replace the Fill Hose;
1. Lay unit on its back.
2. Disconnect inlet hose at inlet valve
3. Stand upright, remove lop,.
4. Detach saddle hose clamp
5. Puli inlet hose up and out of cabinet.
6 Disconnect inlet hose from coupler,
Reinstall new inlet hose in reverse of the above - Be certain
routing
is proper and that there are no twists or kinks
in the hose. Check hose connections for leaks and lest movement of hose in ano out ot caoinei.
some models, both the fill hose and drain hose are permanently attached to the coupler.
To replace the Drain Hose:
1. It is best to leave unit in upright position and remove access panel.
2 Disconnect drain hose from pump casting - CAUTION - be prepared to catch approximately one Í1) quart of
water from pump housing and hose.
3. Disconnect fill hose at inlet (stil! standing upright).
4. Remove top assembly.,
A 2