Kenmore 808353 - Manual (Page 67)

Note lhai the switch numbers on the Ester line chart correspond to switch numbers on the Wirmg diagram.
At the end of the fill phase, the water valve opens as shown by the Ester line chart, and the timer contacts listed below
are now closed (Refer to Figure 70 )
• Power Bus 1 Switch 1
• Timer (Victor - Switch 10
• Motor Power - Switch 20
• Phase Wash - Switch 21
• Heater - Switch 23
The machine is now in its first wash The switch on the motor start relay closes and then opens after the motor reaches
its operating speed As you progress from left to right across the Ester line chart, it is easy to determine which timer
contacts are closed at any point in the cycle This information can then be related to the wiring diagram
Studying and learning has no value until it is applied It is necessary to follow a step-by-step procedure to diagnose a
machine malfunction
For example, lei us assume we have selected a “Normal Wash” and the dishwasher will not ftlL A rule is to always check
the easy and obvious first
1. Is there power to the machine? Be sure the proper connection been has made to the electrical supply. Also check
for a tripped circuit breaker or blown fuse.
2 .
3.
4
Make sure the water supply to the machine is turned on.
Check to be certain the door latch is dosed.
Check to be certain the timer dial has been advanced to the point where the indicator light comes on A short
delay will be present before the machine begins to fill.
Check the float to be sure it is not stuck. It must move freely,
6 4