Figure 18 figure 19, Two level ~ compact models – Kenmore 808353 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

A Removal of Middle Spray Arm

1 Remove stainless steel cotter pin in tower end of pjaslic spray arm spindle underneath the black plastic supply

arm

2 The spray arm and spindle can now be lifted off the supply arm

B Removal of Upper Spray Arm Only

1 From below, in tub, remove two screws which hold spray arm and bearing assembly to plastic distributor

(See Figure IS )

2 The assembly wilt then drop loose If it is desired to remove the arm from the bearing assembly, the two

screws that hold them together are now accessible

NOTE

In Mid-1980 the design of the third spray arm was changed

The

spray arm Is removed by removing

the

center

mounting screw [See Figure 19]

FIGURE 18

FIGURE 19

Two Level ~ Compact Models

The top spray arm water supply system on all 18" Ccompact) dishwashers is completely

externa!

of the wash chamber,

A hose from the back side of the pump housing runs behind the back center of the wash chamber (tub) up to the delivery

tube

To remove: (See Figure 20)

1. Disconnect power supply to dishwasher,

Loosen and remove clamp attaching delivery hose to pump housing

NOTE:

Water remaining in hose artd pump should

be caught in a bowl

Remove four W) screws that attach the delivery tube to the tub assembly.

Remove hose by pulling slowly through the opening in rear of tub.

Reverse procedure to reinstall and check for leaks and kinks.