beautypg.com

Brother FAX-400 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

E R R O R M E S S A G E S

N O R E S P O N S E O R B U S Y

When you are making a transmission this message indicates

that either the other party is busy or that no response has
been received. If you have turned the Auto Redial function
ON (see page IV-1-10), the machine will automatically try

the number again after a few minutes. If you have selected
to turn the Auto Redial function OFF, this transm^sion

will be unsuccessful and transmission verification report

(busy) will be printed out.

N O C O N N E C T A B I L I T Y

When you are the receiving party, this message will indicate
that certain functions—password cannot be enabled

because the sending party's machine is not a Brother
machine.

I D M I S M A T C H

L I N E D I S C O N N E C T E D

This may indicate that the incorrect ID number (for
password, password plus, and secure polling) was used
when the sender made his transmission. Contact the sender
to verify that your ID codes match up correctly. A

transmission verification report (error) will be printed out.

This message may indicate that either the sending or the

receiving party has interrupted the fax transmission (or
reception) operation. If you are the sender, this may also
indicate a missed telephone line connection due to an ID
mismatch or the receiving party being unprepared for
polling, and so on. In such circumstances, check with the

receiving party to learn what is happening at the other end
of the line.

C O M M E R R O R X X Y Y

This message indicates that some communication error has
taken place. "XX YY" represents the error codes used to
provide more detailed information about the error. Refer
to the list shown below.

Error Codes

40 06 — This indicates that a unit which has not been set up

for polling has been polled by another unit.

40 13 — This indicates that the machine has been set up for

secure polling, but the polling request has come
from a unit which is not a Brother machine.

AO 01 — This indicates poor telephone line conditions.

If any error code other than those listed here appears on the
LCD, contact your Brother service center and inform them of

the situation.

V l-7