beautypg.com

Brother FAX-400 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

E R R O R M E S S A G E S

P R I N T E R E R R O R

P R E S S S T O P K E Y

This indicates that the cutter is not at the home position

because a recording paper jam is obstructing the movement
of the cutter inside the machine. First, unplug the machine.
Then open the cover to remove the jammed paper. (Use

caution when handling the paper, as the cutter is quite

sharp.) After the paper

jam has been

corrected,

reset

the

paper roll in position, and close the cover. Finally, plug in
the machine again. The cutter will return to the home
position automatically.

This may indicate overheating due to a problem with the

printing head. Let the unit cool down for one hour or more.
If this does not correct the error, contact your Brother
service center and inform them of the situation.

The cover has not been closed properly. Check the position
of the release levers on both sides inside the unit, and
return them to the upper position, as shown in the
illustration below. Then close the cover.

This may indicate some error related to the recording
paper at manual reception or polling operation. Hang up
the handset when manual reception. Information about
correcting the situation will then appear on the LCD.

M A C H I N E E R R O R X X

P R E S S S T O P K E Y

V I -6

This may indicate an error related to the recording paper.
Press the STOP key or remove the document, and
information about the situation will appear on the LCD.

This may indicate overheating due to overuse. Let the unit
cool down for one hour or more.

I f

this does not correct the

error, contact your Brother service center and inform them
of the situation.
If the error message on the LCD reads "MACHINE ERROR
EA", this may indicate that the document was removed
from the feeder while transmission was still taking place.