To adjust buttonhole stitch density – Kenmore 15358 User Manual
Page 78
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sew slowly and stop the machine when a buttonhole is
completed.
* The front bartack and left row sews first, then the back
bartack and right row.
Cut both needle and bobbin threads leaving about 10 cm
(4") thread ends.
Draw the needle thread to wrong side of fabric by pulling
the bobbin thread. Then, knot the threads.
Insert a pin inside the bartack.
Then cut the opening with seam ripper.
Take care not to cut the stitches.
To repeat buttonhole sewing, turn the stitch selector to
iZD, then back to Q again, as shown.
Now, simply step on the foot control to sew an identical
buttonhole.
10 11
When buttonhole sevi'ing is finished, push the buttonhole
lever upward as far as it wiH go.
13
To adjust buttonhole stitch density:
Set the stitch length control between 0.25 and 1.0 to adjust the
buttonhole stitch density.
66