Kenmore 15358 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Machine
• Threading the machine
* Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with thread coming off
as shown.
|T| Draw the end of thread around the upper thread guide.
m
] While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
T|
13 Firmly draw the thread up and from right to left over the
take-up lever then down into the take-up lever eye.
S]
Slide the thread behind the needle bar thread guide on
the left.
3 Thread the needle from front to back.
E3
24