Changing needle, To remove and attach the foot holder, Extension table – Kenmore 15358 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Extension Table

• Detaching the table

Pull the table away from the machine, as illustrated, for
“free-arm” sewing of cuffs and sleeves. The extension

table can be used as accessory box.

• Attaching the table

Push the extension table until it snaps into the machine.

(1) Extension table
@ Pin
(3) Holes
(4) Tab

(5) Free-arm

Changing Needle

(1) Needle clamp screw
(2) Needle clamp

[TjTurn

off the power switch.

Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering

the presser foot. Loosen the needle clamp screw® by
turning it counterclockwise. Remove the needle from the

needle clamp (2).
Insert a new needle into the needle clamp (2)with the

flat side to the rear. When inserting the needle into the

needle clamp®, push it up as far as it goes. Tighten

the needle clamp screw ® firmly by turning it clockwise.

[UT

see if the needle is good, place the flat side of the

needle onto something flat (e.g needle plate or glass).

The gap between the needle and the flat surface should

be consistent. Never use a bent or blunt needle.

A damaged needle can cause permanent snags or runs

in knits, fine silks and silk-like fabrics.

Flat side
Lado piano
Méplat

Needle

Aguja
Aiguille

To Remove and Attach the Foot Holder

® Set screw

Foot holder

(3) Presser bar

• To remove

Remove the set screw ® by turning it counterclock

wise with a screwdriver.

• To attach

Match the hole in the foot holder @ with the threaded
hole in the presser bar (3). Fit the set screw ® into

the hole. Tighten the screw ® by turning it clockwise with
a screwdriver.