Brother 2500ML - Manual (Page 109)

til^QTEi^er^tONS
Remote Control Commands
You can control your fax machine with the following remote control commands.
Remote control command Detail Operation
95 Changing Fax Forwarding
/Paging setting
1 OFF If you hear one long beep, the change is accepted. If you hear three
2 Fax Forwarding
shoi't beeps, y^'ou can not change it because the conditions (ex.
registering fax forwarding or paging number) have not been
completed. You can register your fax forwarding number by using
4. FAX FWD No. (see page 11-8). Once you have registered the
number, the machine will automatical^ turn to “FAX FWD;ON” 3 Paging
4 FAXFWDNo.
5 FWD No. Confirm
mode. Then, receive a Memory Status List by entering 961 {see page
11-8). Check the List to make sure the Fax Forwarding number you
registered is correct. Then enter the confirmation command 955.
Now the machine will start Fax Forwarding.
6 Fax Storage ON You can set FAX STORAGE ON or OFF.
7 Fax Storage OFF
96 Retrieve FAX
1 Memory Status List You can use a remote fax machine to receive a List or stored fax
2 Retrieve all FAXES
message)s). (See page 11-8.)
3 Erase FAX in the
memory
If yon hear one long beep, you can erase fax message(s) in the
memory.
97 Check the receiving status You can check whether your fax machine has received any fax
1 FAX
message(s). If yes, you will hear one long beep. If no, you will hear
three short beeps.
98 Change Answer Mode
If yuu hear one long beep, y-ou can change the Answer Mode. If you
1 TAD
hear three short beeps, you can not change it.
2 F/T
__
3 AUTO
90 Exit After a long beep, you can exit remote control.
m
11-7