ALTANA Haze-Gloss Manual - Manual (Page 12)

haze 20°60°85°
20° + 60° auto-range 60° + 85°
Select the desired geometry or the
auto-range function (see Chapter 6,
Practical Measuring Hints).
Lower the sample support table
using the hand lever, or the footswitch
in the case of a motorized table.
Insert sample, test surface facing up.
Check the sample for possible surface
defects (e.g. scratches, fingerprints).
The illuminated target marks the
sample port position (see SET UP
Menu: Target)
Release hand lever or footswitch
respectively. Now the support table
moves the sample towards the
sample port.
The measurement is started automati-
cally but can also be started manually
by pressing the operate key.
(see SET UP Menu: Measure autom.)
The measured values and the corre-
sponding geometry/measuring
mode appear in the display.
4. Operation
haze 20°60°85°
20° + 60° auto-range 60° + 85°
Select the desired geometry or the
auto-range function (see Chapter 6,
Practical Measuring Hints).
Lower the sample support table
using the hand lever, or the footswitch
in the case of a motorized table.
Insert sample, test surface facing up.
Check the sample for possible surface
defects (e.g. scratches, fingerprints).
The illuminated target marks the
sample port position (see SET UP
Menu: Target)
Release hand lever or footswitch
respectively. Now the support table
moves the sample towards the
sample port.
The measurement is started automati-
cally but can also be started manually
by pressing the operate key.
(see SET UP Menu: Measure autom.)
The measured values and the corre-
sponding geometry/measuring
mode appear in the display.
4. Operation