Machine parameter editing, Machine parameter editing -21 – Elektron Machinedrum User Manual
Page 29
THE SOUND SYNTHESIS OF THE MACHINEDRUM
21
•
The clear machine operation can be undone by performing the operation one
more time. The message “UNDO MACHINE” will be shown in the display.
MACHINE PARAMETER EDITING
Machines are controlled by up to eight synthesis parameters that are accessed with the
DATA ENTRY knobs.
Press the [SYNTHESIS/EFFECTS/ROUTING] key until the
rightmost text of the machine information area at the bottom left will show “SYNT” for syn-
thesis. The machine parameters are now controlled by the DATA ENTRY knobs.
•
Changes are not stored to the kit unless it is saved. Please see section “SAVING
AND NAMING A KIT”, on page 15 for information about saving kits.
For more information on specific parameters of the different machines, please see “Appen-
dix A: MACHINE REFERENCE“.