Scene mode, Scene edit – Elektron Analog Rytm User Manual
Page 29
KITS AND SOUNDS
21
•
Copy, clear and paste operations are available in the LOAD KIT and SAVE KIT menus.
•
Use the LEVEL knob to scroll through the LOAD KIT and SAVE KIT menus.
•
Once you have assembled a kit you like, or changed it in a desirable fashion, don’t forget to save
it using the shortcut [YES/SAVE] + [FX].
•
A kit that is not used by any pattern is shown with an asterisk symbol following the kit name.
SCENE MODE
Press [SCENE] to enter scene mode. A scene is a collection of fixed parameter locks. It enables an instant
makeover of how the tracks of the active kit will sound, at the touch of a single pad. 12 scenes may be assigned,
one for each of the [PADS].
Press one of the [PADS] when in scene mode to activate a scene. Only one scene may be active at a time.
When active, the pad to which the scene is assigned will glow blue. The
glow half-bright blue. Empty scenes have unlit pads. If the pad of the active track contains a scene, the pad will
exhibit violet color (a mix of the active track color and the scene color, red and blue).
SCENE EDIT
There are 12 assignable scenes available, one for each pad. Make sure SCENE mode is active. Select which
scene to edit by pressing one of the [PADS]. Then press and hold the [SCENE] key for a short while in order to
edit the scene.
•
When SCENE mode is active, [FUNCTION] + one of the [PADS] offers a convenient shortcut to
scene edit mode.
When scene edit is active, the LCD screen left hand side will reveal a list showing, from the top, the scene num-
ber, the number of locked parameters, an option to clear the scene and an option to clear all scenes. Use the
[ARROW] keys [UP] and [DOWN] to navigate this list.
SCENE shows which scene is being edited. Use [ARROW] keys [LEFT] and [RIGHT] to
select another scene.
LOCKS shows the number of parameter locks assigned to the scene. This figure will only
change by adding or removing parameter locks (see below).
when this option is highlighted to clear the scene.
option is highlighted to clear all scenes.
While keeping the scene pad pressed, various parameters can be locked to the scene by turning the DATA
ENTRY knobs. Any parameter, from any of the 13 tracks, can be modulated and locked to the scene. Choose