COP-USA DVR2304SE-B - Manual (Page 36)

Digital Video Recorder User Manual
30
Step3: The setup steps of motion trigger are similar to „Alarm Handling‟. You can
refer to Chapter 4.5.1 Sensor Alarm Handling for more details.
Step4: Click “Setting” button under the Area to display the following
picture as shown in Fig 4-24:
Step5: In the Area tab, you can drag slide bar to set the sensitivity value (1-8). The
higher the value is the more sensitive it is to motion. Since the sensitivity is
influenced by color and time (day or night), you can adjust its value according to the
practical conditions. Left click the grid and drag to delete area. Drag again to add area.
Click icon to set the whole area as detection area. Click icon to clear the set
detection area. Click icon to test the sensitivity as per the local conditions. Once
motion is sensed, it displays a figure icon. Click icon to save the setting. Click
icon, exit the current interface. Fig 4-24 Motion-Area
Note: Prior to setting motion detection field it is recommended that you click
icon to clear the existing field and set afresh.
Step6: Select “All” to setup all channels with the same parameters.
Step7: Click “Apply” button to save the setting.
Step 8: Enter into Schedule tab. The setup steps for schedule for motion based alarm
are similar to normal schedule setup; you can refer to 4.4.1 Schedule for details.
This step is very important for motion based alarm. Even if you have enabled the
motion based alarm for all channels and setup the trigger, you will not see the result of
motion based alarm if no schedule is added.
Fig 4-25 Motion-Schedule
If you have set the schedule for senor based recording in the same timeline, recordings can also be triggered.
4.5.3 Video Loss
Step1: Enter into MenuSetupAlarmVideo Loss tab. Refer to Fig 4-26: