COP-USA NVMS 5000 - Manual (Page 54)

NVMS-5000 User manual
54
¾ Snap
Click button on the toolbar of the selected channel or right click to
choose “Snap” to capture the pictures.
After snapping pictures, a message prompt box will pop up to remind you
the pictures are captured successfully and where the pictures are stored.
Note: Capturing pictures can be realized only in live preview or playback.
¾ Talk
Click button on display window or right click to pop up a menu bar.
Choose “Start Talk” to enable bidirectional audio.
Note: Since NVMS-1000 only allow you to open one device’s talk at the
same time, the system will stop talk with the current device for enabling
new talk with another device which is launching talk.
¾ Broadcast
ķ Click “System” on the menu bar of software at the upper right; choose
“Broadcast” to enter the interface.
ĸ Click button to pop up a window; then check
the devices you want to broadcast, click ǏOKǐbutton to save the
setting.
Ĺ Click button to stop
broadcast.
¾ PTZ Control
Please confirm the parameter of PTZ has been configured correctly before operating PTZ. Click
icon in display window or “Change Camera Setting” under “Device” to enter the interface. Click
“PTZ Setting” to enable PTZ and setup protocol, baud rate and address of PTZ.
Note: Here the protocol, baud rate and address of PTZ must be consistent with the PTZ decoder.
Select the channel and click icon or right click to choose “PTZ Control” to open the control panel of PTZ.
Click the direction buttons to control its rotational direction; drag the slider to control its speed.
Click and buttons to adjust focus, iris and zoom.
Select a preset point and click to operate this preset point or double click the preset point to operate it.
Click ǏCruiseǐbutton to list the cruises. Select a cruise and click button to cruise; click button to stop
cruising.
PTZ can also support track, auto scan, wiper and light function.
5.1.4 Alarm Preview