ChemoMetec SP-100 - Manual (Page 64)

9 Technical specifications
46
analysis is presented in Millions of Cells per ml of the initial Sample. The result is
always shown on the NucleoCounter display. If connected to a PC with
NucleoView installed the result is also displayed on the PC monitor. The viability
in percent can also be displayed on the PC-monitor if both a Total Count and a
Non-Viable Count are performed.
Operation Menu-controlled by means of keyboard and LCD display.
Analysis time When pressing “Run Run Run Run” on the NucleoCounter SP-100 the result will be displayed
within:
30 seconds for a Total Count
60 seconds for a Non-Viable Count
Physical data Weight
Height
Width
Depth
3 kg
26 cm
38 cm
22 cm
Power
See Section 11.5 Power Supply
Input
Fuse
12VDC (11-13VDC)
UL Listed fuse: 600mA/250Vac (UL 248)
Power consumption
NucleoCounter Peak
Ready mode
Standby
25 W
2.5 W
2 mW
Operation conditions Maximum relative humidity 80 percent for temperatures up to 31°C decreasing
linearly to 65 percent relative humidity at maximum 35°C; minimum temperature
15°C.
USB (For image and result
transfer to PC) USB, version 1.1.
Note: Does not support USB Hubs
RS-232 Printer port
(To be used for printer,
SW-updating and result
transfer to PC)
Baud rate:
Data bits:
Parity:
Stop bits:
Flow control: 19200
8
None
1
None
Other environmental operating conditions for the NucleoCounter SP-100:
Indoor use only
Altitude Up to 2000 m
Mains supply Refer to the specifications for the Power supplies in section 11.5 Power supply
Installation Category II (Refer to UL 61010A-1)
Overvoltage Category II (Refer to UL 61010A-1)
Pollution Degree II (Refer to UL 61010A-1)