ChemoMetec SP-100 - Manual (Page 37)

5 Operation of NucleoCounter SP-100
19
Display Text Type 11
Sample ID? Sample ID? Sample ID? Sample ID?
Enter new ID + Enter new ID + Enter new ID + Enter new ID + ↵ ↵ ↵ ↵
New ID=1_ New ID=1_ New ID=1_ New ID=1_
Figure Figure Figure Figure 26 26 26 26. . . . This display text is shown if the digit “ 1” is typed in when the instrument is
in the Ready status or Result status. If the Sample ID is 1234 the display
will be automatically updated during the typing in of the remaining digits
“
2”, “3” and “4”.
The ID will appear in the display and if the SP-100 is connected to a PC with SemenView
installed the Sample ID will also appear on the PC screen.
Display Text Type 2
SP SP SP SP- - - -100 100 100 100
Ready Ready Ready Ready
ID:1234 DF=201 ID:1234 DF=201 ID:1234 DF=201 ID:1234 DF=201
Figure Figure Figure Figure 27 27 27 27. . . . The NucleoCounter SP-100 is ready. Sample ID is 1234
Display Text Type 9
Cells/ml Sample Cells/ml Sample Cells/ml Sample Cells/ml Sample
455.0 455.0 455.0 455.0 mill. mill. mill. mill.
ID:1234 DF=201 ID:1234 DF=201 ID:1234 DF=201 ID:1234 DF=201
Figure Figure Figure Figure 28 28 28 28. . . . Cell density of sample with ID 1234
The Sample ID can only be typed in when the instrument is in the “ Ready” status or
“ Result” status.
The sample ID is shown in the bottom line of the display both in “ Ready” status or
“ Result” status (prior to and subsequent to the measurement).
A digit can be deleted by pressing the “ Del” button.
When only a “ 0” is typed following by pressing the ↵ ↵ ↵ ↵ button the ID will be cleared from
the display. If a Sample ID is not typed in or cleared then “ ID:-“ is displayed
After each measurement the Sample ID will automatically be cleared from the memory
of the instrument. This means that when performing consecutive measurements on the
same sample, the Sample ID must be typed in for each measurement.