BUCHI NIRCal - Manual (Page 142)

NIRCal 5.5 Software Manual
142 NIRCal 5.5 Manual, Version A
Lifecycle: Edit
A calibration stored in the DB has the "created" status and " read-only" mode. The active calibration
can be edited with the Lifecycle / Edit.
There is no possibility to edit an approved calibration.
NOTE
If the first calibration in the project is approved, this calibration can never be extended with new
spectra. Work around: use the spectra GUIDs to create the same project, the calibration protocol can
be a valuable help.
Lifecycle: Save
Calibrations after optimization can be stored into the database with this LC function.
It is not available, in case the project is not yet stored in the database.
NIRCal tests each quantitative calibration, if only one property has been selected (single property
calibration). In case there are several properties, the calibration is not stored, the user gets a warning.
There is a question in case after a modification the calculation is not yet made:
Yes: the calculation is necessary for "Approved" status.
No: gives the possibility to save the calibration into the database without recalculation (quick save at
the end of the day).
NOTE
Prediction Protocols are only available for calibrations, which are calculated and not modified after the
calculation.