BUCHI Encapsulator B-395 Pro - Manual (Page 37)

6 Operation
37 B-395 Pro Operation Manual, Version C
6 Operation
This chapter gives examples of typical instrument applications and instructions on how to operate the
instrument properly and safely. See also section 2.5 “Product safety” for general warnings.
6 .1 Starting up the instrument
• Make sure the Encapsulator B-395 Pro is properly connected to the mains supply.
• Carry out a final installation check (see section 5.8) before every bead production.
• Switch on the Encapsulator B-395 Pro. The system runs an internal check.
6 .2 Main screens
All controlling systems for bead production are incorporated in the control unit. Vibration, pump speed,
light intensity and electrostatic dispersion are controlled on two touch screens. Air pressure is regu-
lated with the pressure regulating valve. The integrated stroboscope lamp allows real time jet breakup
control.
After the internal system check the two touch screens show the following main screens:
The upper touch screen is for the control of vibration
frequency and electrode tension.
Screen 6-1: Upper touch screen
The lower touch screen is for the control of the sy-
ringe pump and the magnetic stirrer speed.
The air pressure is also indicated on this screen,
however it is controlled manually through the pres-
sure regulating valve.
Screen 6-2: Lower touch screen
NOTE
Icons with a thick bar at the bottom e.g.
on
off
activate/stop a process or lead to another screen.