Panasonic KX-P3626 - Manual (Page 52)

©@[MlDuD©[ii^ [RR^D^DDD (pMa@ffii©@@Q 3 D[^ii^^
The Command Reference program allows you to access a detailed explanation of each software
command on the screen. Each displayed explanation can be printed out if required.
Before using the Setup Disk, it is recommended that you make a back-up copy and store the original
in a safe place.
Note:
• Use the DISKCOPY command of the operating system to make a back-up copy. Refer to your DOS
manual for further information.
• You may find it convenient to install the Setup Disk programs directly onto your C Drive, rather than
reading them from the Setup Disk each time a change is necessary. Either method is acceptable.
To perform an automatic installation of the Setup Disk files onto your C Drive, refer to page 32.
Insert your Setup Disk into either drive A or B. 1
2 Type A: (or B:) and Press [ Enter].
0 Type CMDREF
Press [Enter].
5 The first screen is an introduction
to the operation of the Setup Disk.
Please read through it and
press any key to continue.
(If your display is monochrome,
press “M” key.)
Screen 1 will be displayed.
0 Press (D or (T) .
Select an emulation.
Select Run from the File menu. 2
2 Type A:\CMDREF (or B:\CMDREF)
^ Click |0K| (or Press [ Enter]).
Screen 1
«Panasonic KX-P3626 command reference utility (xxxxxxxxxxx)»
------ SELECT EMULATION-------
rEPSON"
IBM
l T ] / | i l
(Enter]
(E]
Select emulation
Set emulation
Exit to DOS
Note:
• You can proceed through the Command Reference program using a computer mouse or your
keyboard. Highlight the desired item and click the left mouse button, or follow the directions on your
screen for keyboard operation.
• There is a list of proportional spacing tables after the software commands list. If you want to see a
proportional spacing table, select your desired table and press [ EnteT] .
52