Panasonic KX-P3626 - Manual (Page 32)

Imil'ial
This Setup Disk can only be used in an IBM-PC or a compatible computer with a 3.5" fioppy
disk drive.
Before using the Setup Disk, it is recommended that you make a back-up copy and store the original
in a safe place.
This printer has been factory set to operate with most of the popuiar software packages. In
most cases there will be no need to change the initial setup items. Refer to pages 28-31 to
verify that the factory settings meet your requirements. If no changes are required, you should
be ready to print.
C
S£.
5‘
zr
(D
(/)
(D
C
■O
a
w'
ytr
Note:
• Use the DISKCOPY command of the operating system to make a back-up copy. Refer to your
DOS manual for further information.
• You may find it convenient to install the Setup Disk programs directly onto your C Drive, rather
than reading them from the Setup Disk each time a change is necessary. Either method is
acceptable.
To perform an automatic installation of the Setup Disk files onto your C Drive, follow the steps
below:
1. Insert the Setup Disk into drive A or B.
2. Type A: (or B:) and press [ Enter).
3. Type INSTALL and press ( Enter ].
This procedure automatically creates a directory called 3626 and copies all of the programs from
your Setup Disk onto your C Drive. If you want to run the Initial Setup Program, press [2 • If you
want to exit, press (W].
To recall the programs from your C Drive.
At your C; \ > prompt, type CD 3626 and press [ Enter ].
Type SETUP and press [Enter] .
Select Run from the File menu.
Type C:\3626\SETUP and click OK| (or press [ Enter] ).
Be sure to type SETUP as one word. If not, you will receive a Syntax error message.
Running the Initial Setup Program
Insert your Setup Disk into either drive A or B.
2
Type A: (or B:) and press [Enter].
2
Select Run from the File menu.
3
Type SETUP
3
Type A:\SETUP (or B:\SETUP)
4
Press [Enter].
4
Click OK (or Press [Enter]).
32