Preparation, Process unit installation, Important – Panasonic KX-P6100 User Manual
Page 10: Open the plastic bag and take out the process unit, 2 setup, Chapter, Printer stands (nstaffation o
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter
2 Setup
Preparation
Printer Stands (nstaffation
O
Lift the printer by holding its front side
and remove both the printer stands by
firmly sliding them downward.
© Turn both the printer stands around and
install them into the printer.
O .
--<11
YMi
© j
Process Unit Installation
Important:
To prevent any damage to the Process Unit,
observe the foiiowing cautions.
• Do not touch the green drum surface. Lift the
Process Unit by tabs.
• Do not expose the Process Unit to light for more
than 5 minutes.
• Do not keep the Process Unit near dust or dirt.
• Do not place the Process Unit in a high humidity
area and keep it out of direct sunlight.
Open the left cover by gently pulling the
cover release tab.
2 Remove the Process Unit by holding the
green labeled tabs and pulling it toward you.
Open the plastic bag and take out the
Process Unit.
4 O Remove the sealing film.
© Remove the protective sheet.
and pushing it firmly into the printer.
10