Yamaha RX-V1065 - Manual (Page 79)

Troubleshooting
Error message Cause Remedy
See
page
E-7:NO MIC The optimizer microphone was Do not touch the optimizer microphone during “Auto 19
unplugged during the “Auto Setup"
procedure.
Setup”.
E-8:NO SIGNAL The optimizer microphone does not Check whether the microphone is properly placed. 19
detect test tones.
Check whether the speakers are properly placed and
connected.
lO, 11
The optimizer microphone or OPTIMIZER MIC
Jack may be defective. Contact the nearest Yamaha
dealer or service center.
E-9:USER CANCEL “Auto Setup" was canceled due to an
inappropriate user operation.
Run “Auto Setup” again. 19
E-10:INTERNAL
ERROR
An internal error occurred. Run “Auto Setup” again. 19
After Auto Setup
Error message Cause Remedy
See
page
W-1 :OUT OF PHASE Speaker polarity is not correct. This Check the polarities (+, -) of the displayed speaker. 12
message may appear depending on the If they are correct, the speakers work properly even
speakers even when the speakers are
connected correctly.
when this message is displayed.
W-2:OVER 24m (80ft) The distance between the speaker and the Bring the speaker within 24 m (80 ft.) area around —
listening position is over 24 m (80 ft). the listening position.
W-3:LEVEL ERROR The difference of volume level among Recheck the speaker positions and make sure all —
speakers is excessive. speakers are placed in a similar environment.
Check the polarities (+, -) of the speakers. 12
We recommended that you use speakers with the
same or similar specifications.
—
Adjust the output volume of the subwoofer. —
W-4:CHECK PRNS Presence speakers were not detected Check the presence speaker connections and perform 11, 56
during measurement with “Extra Speaker measurement again. If presence speakers are not
Assignment" set to “Presence”. connected, set the “Extra Speaker Assignment” to
other than “Presence”.
76
En