Yamaha RX-V1065 - Manual (Page 53)

Editing surround decoders/sound field programs
Although the field sound programs would satisfy you as
they are with the default parameters, you can arrange
sound effect or decoders suitable for acoustical conditions
of sources or rooms by setting the parameters.
• You caiinol configure ihc parameters when "Memory Guard” is set to
”On" (page 60).
1
Turn on the video monitor connected to this
unit.
2
Press [30N SCREEN on the remote control.
The GUI screen appears on the video monitor.
3
Press HCursor V to select “Setup” and then
press QIENTER.
4
Press HCursor A / V to select “DSP
Parameter” and then press HENTER.
Sound field program
Sound field parameters Set values
5
Press HCursor A / V
to select “Program
Name” and then press HCursor
select a sound field program to edit.
6 Press HCursor A / V
to select a parameter to
edit and then press HCursor
change the setting.
For details on functions and adjustable ranges of the
sound field parameters, see “Sound field parameters”
on this page.
• Repeat steps 5 and 6 to change other sound field program
parameters.
7
To turn off the GUI screen, press [SON
SCREEN.
To initialize the parameters of the selected sound field
program, press
HCui'SOI' V repeatedly to select
“Initialize” and then press HCursor l>. Then, press
HCursor [> again to execute the initialization or
HCursor
• The default sellings are marked wilh
CINEMA DSP basic parameters
DSP Level
Adjustable range: -6dB to OdB* to +3dB
Fine adjusts an effect level (level of the sound field effect
to be added). You can adjust the level of the sound field
effect while checking sound levels. Adjust “DSP Level” as
follows.
• The effect sound is too soft.
• There are no differences between effects of the sound
field programs.
^Increase the effect level.
• The sound is dull.
• The sound field effect is added too much.
^Reduce the effect level.
Dialogue Lift
Choices: 0* to 5
Use this feature to adjust the vertical position of the
dialogues in movies. The ideal position of the dialogues is
at the center of the video monitor screen.
-The Ideal dialogue
position
If the dialogues are heard at the lower position of the video
monitor screen, increase the value of “Dialogue Lift”.
Move up to the Ideal
dialogue position
When the value is set to zero, the position is at the lowest.
The position gets higher as you increase the value.
Notes
* This setting is available only when "Extra .Speaker Assignment“ is set to
"Presence" (page 56).
• You cannot move the dialogue position down from the initial dialogue
position.
3D DSP
Choices: On*, Off
When CINEMA DSP 3D is enabled, sets whether to use
sound field programs in 3D mode.
50 En