Yamaha RX-V1065 - Manual (Page 69)

APPENDIX
Troubleshooting
Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
Problem Cause Remedy
See
page
This unit does not The internal microcomputer is frozen due Disconnect the power cable from the AC wall outlet, —
operate properiy. to an external electric shock (such as
lightning or excessive static electricity) or
by a drop in power supply voltage.
wait about 30 seconds and then plug it in again.
This unit suddeniy The internal temperature is too high and Wait about 1 hour for this unit to cool down and then —
enters the standby the overheat protection circuitry has been turn it back on.
mode activated.
The protection circuitry has been activated Check that the speaker impedance setting is correct. 64
because of a short circuit, etc.
Check that the speaker wires are not touching each
other and then turn this unit back on.
—
The sleep timer has turned off this unit. Turn on this unit and play the source again. —
This unit faiis to turn The power cable is not connected or the Connect the power cable properly to an AC wall 18
on or enters the plug is not completely inserted. outlet.
standby mode soon
after the power is
turned on.
The speaker impedance setting is
incorrect.
Set the speaker impedance to match your speakers. 64
(When this unit is turned back on and Make sure that all speaker cables between this unit 11
■^CHECK SP WIRES!^’ is displayed.) The
protection circuitry has been activated
because this unit was turned on while a
speaker cable was shorted.
and speakers are connected properly.
This unit cannot be The internal microcomputer is frozen due Disconnect the power cable from the AC wall outlet, —
turned off. to an external electric shock (such as
lightning or excessive static electricity) or
by a drop in power supply voltage.
wait about 30 seconds and then plug it in again.
No picture. An appropriate video input is not selected Select an appropriate video input on the video —
on the video monitor. monitor.
The external video component is Connect the external video component to the video 14, 15
connected to one of the HDMI 1 -4 jacks input jacks other than the HDMI 1-4 jacks or connect
while your video monitor i.s connected to
the MONITOR OUT (COMPONENT
VIDEO or VIDEO) ¡acts.
the video monitor to the HDMI OUT Jack.
This unit outputs the video signals not Displays the advanced setup menu and select 64
supported by the video monitor connected "VIDEO” in ”INIT” to reset the video parameters.
to the HDMI OUT jack.
Displays the advanced setup menu and set 64
■‘MON.CHK” to -‘YES”.
Video signals are input from a game Connect the video monitor to the MONITOR OUT 14
console while your video monitor is
connected to the HDMI OUT jack.
(COMPONENT VIDEO) jacks.
Non-standard video signals are input. Connect the video monitor to the MONITOR OUT 14
(COMPONENT VIDEO or VIDEO) jacks.
66
En