Yamaha RX-V1065 - Manual (Page 21)

Connections
An indoor FM antenna and an AM loop antenna are
supplied with this unit. Connect these antennas properly to
the respective jacks.
Indoor FM antenna Outdoor AM antenna
Connect a 5 to 10 m (16 to
33 ft) vinyl-covered wire,
and extend it outdoors
(use the AM loop antenna
together with this
antenna). AM loop
antenna
№
Ground (GND terminal)
The GND terminal is not for earth grounding.
To reduce noises, connect a ground bar or a
vinyl-covered wire with a copper plate at its tip,
and place it in the moist ground.
After all connections are complete, plug the power cable
of ihis unii inlo an .\C' \\ all oullel.
To the AC wall outlet
-Power cable
■ The supplied aiileniias are normally sensitive enough lo ohlain good
reception.
■ Position the AM loop antenna away from this unit.
■ If you cannot gel good reception, we recommend thal you use an outdoor
antenna. For details, consult ihe nearest aulhorized Yamaha dealer or
service center.
■ Always use ihe AM loop antenna even when the outdoor antenna is
connected.
Assembling the AM loop antenna
Connecting the AM loop antenna
The wires of the AM loop antenna have no polarity. You
can connect either wire to the AM terminal and the other
to the GND terminal.
1
Press ®MAIN ZONE ON/OFF on the front
panel (or HPOWER on the remote control)
to turn on this unit.
2
Press ®MAIN ZONE ON/OFF (or
OIPOWER) again to turn off this unit
(standby mode).
• The unit needs a few seconds until ready to play back.
• You can also turn on ihis unit by pressing ©SCENE (or [SjSCENE).
• This unit consumes a small amount of electricity even in the standby
mode. We recommend disconnecting the power cable from the AC wall
outlet.
Caution
Do not unplug this unit while it is turned on. Doing so
may damage this unit or cause the settings of this unit
to be saved incorrectly.
18 £n