Yamaha RX-V1065 - Manual (Page 26)

Playback
Registering input source/sound field
program
Select the desired input source/sound field
program and then press and hold ©SCENE (or
©SCENE) key to edit until “SET Complete”
appears on the front panel display.
• Il'you change ihc input source selling, register the remote control code of
an external component to the input source (page 63).
Switching remotely controlled external
components linked to scene selections
You can operate an external component with the remote
control of this unit by setting a remote control code for the
external component for each input source. Setting remote
control codes for desired input sources allows you to
switch between external components linked to scene
selections.
1
Register the remote control code of an
external component to the desired input
source (page 63).
Note
• This Fcalurc is not available for TUNER. vSIRIUS and XM input
sources.
2
While holding down the desired ©SCENE
key, press and hold the ©Input selection
key to which you registered a remote control
code in step 1.
From now on the external component can be remotely
controllable just by selecting a scene.
1
Press ©ON SCREEN on the remote control.
The GUI screen appears on the video monitor.
Use HCursor A
/
V
repeatedly to switch the
page and HCursor <1/0 repeatedly to
select the desired input source.
Category Input source
Select Media USB, DOCK, SIRIUS, XM,
TUNER, PHONO, V-AUX,
MULTI CH
Select Input HDMH-4, AVI-6, AUDIO 1/2
• If an input source you want lo select is available in "Select Scene", you
can select the desired input source and sound field program at once.
3
Press QIENTER.
1
Press iDMUTE on the remote control to mute
the audio output.
The MUTE indicator on the front panel display
flashes while audio output is muted.
2
Press ©MUTE again to resume audio
output.
You can adjust the balance of the high frequency range
(Treble) and low frequency range (Bass) of sounds output
from the front left and right speakers to obtain desired
tone.
1
Press (©TONE CONTROL on the front panel
repeatedly to select “Treble” or “Bass”.
The current setting is displayed on the front panel
display.
Treble
0
=
0
dB
2
Rotate the ©PROGRAM selector to adjust
the frequency range.
Control range: -lO.O dB to +10.0 dB
The display returns to the previous screen
automatically in few seconds.
Notes * •
• The lone control settings arc not effective when this unit is in the Ptirc
Direct mode or "MULTI CH" is selected as an input source.
• If yon set the halanec extremely off. sounds may not match those from
other channels well.
Category Input source
Select Scene BD/DVD, TV, CD, RADIO
Use Pure Direct mode to enjoy the pure high fidelity
sound of the selected source. When Pure Direct mode is
activated, this unit plays back the selected source with the
least circuitry.
23
En