Yamaha RX-V1065 User Manual
Page 72
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
Problem
Cause
Remedy
See
page
No picture or sound.
The number of the connected HDMI
components is over the limit.
Disconnect some of the HDMI components.
The connected HDMI component does not Connect an HDMI component that supports HDCP.
81
support high-bandwidth digital copyright
protection (HDCP).
Problem
Cause
Remedy
See
page
FM stereo reception is
You are too far from the station
Check the antenna connections.
18
noisy.
transmitter or the input from the
antenna is weak.
Replace the outdoor antenna with a more
sensitive multi-element antenna.
—
Switch to monaural mode.
48
There is distortion, and
There is multi-path interference.
Adjust the antenna height or orientation, or
—
FM
clear reception cannot
be obtained even with a
good FM antenna.
place it in a different location.
The desired station
You are in an area far from a station or
Replace an outdoor antenna with more
—
cannot be tuned into
an input from the antenna is weak.
sensitive multi element antenna.
with the automatic
tuning method.
Tune in manually or by direct frequency
tuning.
29
The desired station
The signal is weak or the antenna
Adjust the AM loop antenna orientation.
18
cannot be tuned into
with the automatic
tuning method.
connections are loose.
Use the manual tuning method.
29
There are continuous
Supplied AM loop antenna is not
Connect the AM loop antenna correctly even
18
AM
crackling and hissing
connected.
if you use an outdoor antenna.
noises.
The noises may be caused by lightning,
It is difficult to completely eliminate noise.
18
fluorescent lamps, motors, thermostats
but it can be reduced by installing and
and other electrical equipment.
properly grounding an outdoor AM antenna.
There are buzzing and
whining noises.
A TV set is being used nearby.
Move this unit away from the TV set.
—
Problem
Cause
Remedy
See
page
This unit cannot
receive the HD Radio
signals of the
selected radio station.
The radio station provides analog FM/AM Select other radio stations that provides the HD Radio
radio service only.
service.
The signal is too weak.
Adjust the antenna position.
Use a high-quality FM/AM antenna.
“Audio Mode” in the Option menu is set
to “Mono”.
Set “Audio Mode” to “Auto”.
48
69 En