beautypg.com

Power switch, Mode check button, Breaker button (bottom panel) – Panasonic AG-DP800HP User Manual

Page 9: Earphone jack, Audio input connectors fm 26p vtr connector, Speaker, Audio monitor level control, Shutter switch

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SHUTTER Switch

This sets the electronic shutter ON or OFF.

OFF: The electronic shutter is not activated.

ON: The electronic shutter is activated. The shutter speed is set using

the SET + or SET - switch.

S/S: The synchro scan shutter mode is established.

The shutter speed can be changed almost continuously from about

1/60 to 1/200 by operating the SET + and SET - switches.

POWER Switch

ON:

SAVE:

OFF:

The entire camera recorder is operated.
The recorder is set to the power save status.
The VTR START (REC start) operation can be performed but it

takes some moments for the recording to commence. The power
save mode is restored when the VTR START (REC stop) button is

pressed.
Power to the camera recorder is switched off.

MODE CHECK Button

This enables the settings of the camera switches to be checked on
the viewfinder.

BREAKER Button
(Bottom panel)

If trouble should cause an excessively high current to flow inside

the camera recorder, the circuit breaker is tripped to cut off the

power automatically and protect the unit. Push this button in after
inspecting inside the product and taking corrective action. The
power is restored if no trouble has occurred.

Earphone jack

The sound can be monitored by connecting an earphone to this

jack.

When

connected, no sound is heard through the speaker.

Audio Input Connectors

fm 26P VTR Connector

Speaker

External microphones or line input signals are connected to these

connectors.

This is for a back-up VTR. The AG-7400 VTR or similar model can

be connected.

•Do not connect the Remote Control Unit (RCU).

The sound can be monitored through this speaker,

•The sound from the speaker is automatically cut off when an

earphone is connected to the earphone jack.

•The MONITOR switch is used to select the channel whose sound

is to be monitored.

Audio Monitor Level Control

This is used to adjust the volume of the sound which is being

monitored.