Panasonic AG-DP800HP - Manual (Page 23)

VTR Start/Stop Switch
Lens Cable (12-pin)
Focus Ring
Zoom Ring
Qj]
Iris Ring
Flange Back Control Ring
Macro Ring
Flange back clamp knob
Power/Manual Zoom Selector
Switch
This easily accessible switch is for handily starting and stopping the
VTR recording, When it is pressed once, recording commences;
when pressed again, recording stops. When this lens is mounted
on the camera recorder, the VTR can be controlied by either this
switch or the VTR start/stop switch on the camera.
This cable is connected to the iens connector.
Turn this ring to bring the subject into focus.
The size of the picture can be adjusted by setting the power/manuai
zoom selector switch to MANU and then turning this ring.
The iris is adjusted by setting the lens iris selector switch to M and
then turning this ring.
Be absoiutely sure to adjust this ring when replacing the lens or
when attaching the lens for the first time.
The flange back adjustment is performed by loosening the flange
back clamp knob and then turning this ring.
Close-up shooting is achieved by setting the lens all the way to the
wide position and then rotating this ring.
Use this knob for clamping purposes after the flange back has been
adjusted.
When this is set to SERVO, the zoom can be adjusted using the
power zoom control switch; when set to MANU, it can be adjusted
using the zoom ring.
23