BendixKing SKYMAP IIIC - Manual (Page 55)

DETAILED OPERATION
types listed above.
Once a suitable data output type has been selected on your GPS/LORAN and it has a fix,
switch on your Tracker IIIC and from the Main Menu Screen, press Key 1, DATA IN/OUT.
Screen 35(T), Data input/output Setup and Test Screen will be displayed.
Screen 35(T): Data Input/Output Setup and Test Screen
If your GPS or LORAN is correctly connected, switched on and outputting data, your
Tracker IIIC will automatically start to read and decode the incoming data. There is no
need to set an input type on the Tracker IIIC as this is done automatically.
DETAILE
D
OPE
RATION
After a few seconds if data is being received, the word YES will appear next to the
RECEIVING NAV DATA: heading. The type of data being received will then be displayed
beside the DATA INPUT: heading.
If the data being received contains valid fix information (i.e. your GPS or LORAN has a fix)
the word YES will appear next to the NAV DATA VALID: heading. Once the unit is
receiving and validating the incoming data you are ready to navigate using Tracker IIIC 's
advanced features.
Press Key 1, PREV PAGE, to return to either the Installation & diagnostics Cover Screen
or the Main Menu Screen.
Rev 9 Jul 2006 3-12 Skymap/Tracker IIIC Pilot's Guide