BendixKing SKYMAP IIIC - Manual (Page 112)

SETUP SCREENS
GPS Receiver Information Log
Screen 31: GPS Receiver Information Screen (Skymap IIIC only)
Most of the information on this Screen is technical engineering information about the
internal GPS receiver. The Total Fix Hours figure increases only during the periods when
the GPS receiver has a 2D or 3D fix. You can if you wish also reset these figures along
with the Total Unit Hours Run value by using Screen 33, Memory Clear Screen.
Clear Memory
APPE
NDICES
make a mistake, however, you are allowed to make as many attempts as you need to
Screen 32: Memory Clear Entry Screen
All the routines, which can clear the unit’s memory are protected by your PIN, specifically
to prevent any unauthorised person wiping out the valuable data contained in memory.
Therefore, when you enter this Screen the cursor will be positioned over the first of four
question marks. You must enter your PIN at this stage before you can proceed to the
memory clear functions on Screen 33. (The factory default PIN is 1234). As soon as the
fourth digit of a correct PIN is entered, the unit will call Screen 33. If the PIN entered is
incorrect the display will switch immediately to Screen 25 (PIN INCORRECT) and then
take you back to Screen 28, the Cover Screen for Installation and Diagnostics. If you do
Rev 9 Jul 2006 A-15 Skymap/Tracker IIIC Pilot's Guide