BendixKing SKYMAP IIIC - Manual (Page 40)

QUICK REFERENCE GUIDE
R/W SURFACE REQ: Sets the runway surface required for ten nearest airports.
EXTENDED TRACK: Turns on or off the extended track line, which is drawn ahead of
your present position in the direction of your present track.
AUTO ZOOM: Turns on or off. When flying the last leg of a flight plan or when flying a
DIRECT TO, as soon as the distance to the destination drops below ½ the scale bar
setting, the unit automatically zooms. Auto Zoom can be disabled by simply pressing the
ZOOM OUT key.
AUTO DECLUTTER: Turns on or off. If a higher priority icon label (Airport) is found to clash
with a lower priority icon label (City) already on the screen, the lower priority icon label will be
removed.
Q
U
IC
K
R
E
F
E
R
E
N
C
E
nitial
ressed
KEY BEEP: Turns the key beep on or off.
LOGGING RATE: Sets the rate in seconds at which you log your position and loads it into a
2000 point cyclic memory. To log a specific flight use the CLEAR LOG key in the Clear
Memory screen (please refer to the Clear Memory section below). The flight can be
replayed in DEMO MODE (please refer to the selecting DEMO MODE section above).
POSITION REF: Defines the reference to which your position is given in MAP MODE,
either to all available data, VORs only or VORs and Airports only.
AIRSPACE ALERT: As the aircraft is about to cross an airspace boundary, a warning
appears on the screen in MAP mode.
Next Screens 1, 2, 3 and 4 are accessed
by repeatedly pressing the NEXT key.
They allow you to choose the level of
zoom at which you wish each of the
classes of data to become visible and at
which level of zoom you want their
corresponding labels to become visible.
You can also set the icon or line style for
many of the data classes and set their
display colours for both TOPO ON and
TOPO OFF display modes.
The LOGGING RATE setting on the i
MAP SET UP screen governs the
spacing of the LOG TRAIL marks.
Turning the LOG TRAIL off will prevent
the position dots from being displayed on
the MAP, however the flight data will still
be logged for playback or download to a
PC.
Any changes made in any of these
screens will be saved once the SAVE &
EXIT key has been pressed. At any time
the RESET VALUES key can be p
to return your unit to the default settings
on that particular screen.
Rev 9 Jul 2006 2-11 Skymap/Tracker IIIC Pilot's Guide