BendixKing SG 465 System EFS 40/50 - Manual (Page 15)

System Configuration
1.1 Issued 8/10 SW 04/05/06/07/08/09/10/11/12/13/14/15/16
GENERAL
Various configurations of the
E F S 40/50 system are currently
available to fulfill the particular
needs of the user. These config-
urations are differentiated by the
number of display units, type of
mode controller, number of sym-
bol generators and the interfac-
ing equipment.
The basic EFS 40 ( 2 tube four
inch Electronic Flight Instrumen-
tation System) consists of:
• 1ea EHSI Control/Display
Unit (ED 4 6 1 )
• 1 ea EADI Display
Unit (ED 4 6 2 )
• 1 ea EADI control
panel (CP 4 7 0 )
• 1 ea Symbol Generator
( S G 4 6 5 )
• Or 1 ea remote EFIS
Control Panel (CP 4 6 7 )
• 1 ea EHSI Display
Unit (ED 4 6 2 )
• 1 ea EADI Display
Unit (ED 4 6 2 )
• 1 ea Symbol Generator
( S G 4 6 5 )
The basic EFS 50 (2 tube five
inch Electronic Flight Instrumen-
tation System) consists of:
• 1 ea remote EFIS Control
Panel (CP 467)
• 1 ea EHSI Display
Unit (ED 5 5 1 A ) ,
• 1 ea EADI Display
Unit (ED 5 5 1 A )
• 1 ea Symbol Generator
( S G 4 6 5 )
Beginning with software 09, a
configuration option was added
allowing an MFD only installation.
This option removes the heading
bug from the display allowing the
MFD SG to stand alone without
any other symbol generator in
the installation. The display unit
in this case can be either an ED
462 or ED 551A. The control
panel must be a CP 469A.
o
MFD ONLY - no selected
heading bug.
Two new configuration options
for display unit (DU) type were
also added with software 09.
These options allow the MFD SG
to drive a 5” ED 551A MFD dur-
ing normal operation and change
to either ED 461 or ED 462 EHSI
and ED 462 EADI during standby
o p e r a t i o n .
o
MFD - ED 551A
EHSI - ED 461
EADI - ED 462
o
MFD - ED 551A
EHSI - ED 462
EADI - ED 462
SYSTEM CONFIGURATION
Section 1mp 9/8/10 7:44 PM Page 1.1