Waterworks R.W. Atlas Low Profile Concealed Tub Filler With Handshower and Metal Lever Handles - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
RW ATLAS
Low Profile Concealed Tub Filler with Handshower
INSTALLATION GUIDELINES
Page 1 of 3 1.15.2013
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS LOW PROFILE CONCEALED TUB FILLER WITH HANDSHOWER WITH METAL WHEEL
HANDLES (STYLE# RWTF01) & METAL LEVER HANDLES (STYLE # RWTF10).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Metal Wheel Handles
Style No. RWTF01
Metal Lever Handles
Style No. RWTF10
SPECIFICATIONS:
Fitting Hole Diameter: 1-3/8"
Handle Spread Maximum: 12"
Handle Spread Minimum: 8"
Inlet Connection Size: 3/4"
Inlet Connection Type: Male NPT
Maximum Deck Thickness: 1"
Minimum Deck Thickness: 1/4"
Recommended Water Pressure: 45psi
Restricted Maximum Flow Rate (Handshower): 2.5 gpm
For use with automatic compensating valves
rated at 2.5gpm.
Spout Reach: 7-1/2"
IMPORTANT:
¾ NOTE: The screw on the top of the handle assembly,
on the front of the handle assembly, on the top of
the spout assembly, and on top of the handshower
are aesthetic and do not serve any mechanical
purpose and should not be removed.
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Product should be on-site prior to rough-in. This
allows the installer to visualize the installation and
verify the center spread.
¾ Check tub deck and tub measurements to assure the
spout projects far enough into the tub.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ For proper installation, the deck surface should be
installed prior to mounting this product.
¾ An access panel is required for future servicing.
¾ Install accessible hot and cold service stop valves to
facilitate servicing.
¾ Run 3/4" supply lines for maximum flow.
¾ DO NOT use putty on deck fittings. Upper and lower
washers are provided.