Waterworks Julia Wall Mounted Articulated Pot Filler with Metal Cross Handles - Manual

Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc. 10.10.06
Julia Pot Filler With Cross Handle
JUKM31
These guidelines have been prepared for the professional contractor to aid in the installation of:
JULIA POT FILLER WITH CROSS HANDLE (JUKM31) All dimensions are based on
original specification and are subject to change and variation. Please consult your Design Associate
for current specifications.
2 1
2
"Ø
5 1
4
"
8 1
4
" 12 1
8
"
2 1
4
"
2 5
8
"
22 1
4
"
6 3
4
"
IMPORTANT
To ensure this product is installed properly, you
must read and follow these guidelines.
The owner/user of this product must keep this
information for future reference.
Be sure your installation conforms to local codes.
This product must be installed by a professional
contractor.
Inspect this product to assure you have all parts
required for proper installation.
Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface
ROUGH IN:
1. Determine the ideal location of the faucet body
based on the clients preference.
2. Finish the rough in by installing a well supported
1
2
" copper.
REQUIRED: Copper supply must be secured,
plumb, and level. See Figure 1. Failure to properly
secure the pipes will cause the faucet to sit
crooked.
3. Make sure a 1 3
8
" hole is cut in the mounting
surface to allow for proper mounting.
INSTALLATION:
1. Slide the escutcheon (1,2) back towards the
handle then loosen the four - 1.5 mm set screws
(16) and remove the spout adapter (3,4) from the
spout.
2. Dry fit the spout adapter onto the 1
2
" copper. Cut
the copper to the proper length by making sure
the copper does not protrude past the end of the
spout adapter.
3. Remove O-rings (4) from spout adapter, then
solder it to the copper pipe. Allow to cool and
reinstall O-rings.
4. Push the faucet onto the spout adapter and tighten
the four set screws.
5. Slide the escutcheon flush to the wall; apply
silicone to the back of the sliding escutcheon as
needed.
6. Unthread the aerator assembly (29-31) from the
spout. Carefully open the valves to flush out any
debris in the supply lines.
7. Inspect all connections for leaks. Reinstall the
aerator assembly
8. To access the valve cartridge:
a. Disassemble the index assembly (11-15) as 1
unit from the handle by lifting the ring (15) off
of the handle.
b. Insert a small bladed screw driver into the
handle and loosen the screw (10) then pull the
handle off the cartridge (6).
c. Unthread the cover (7) from the cartridge (6)
from the spout body (5).
If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am-7pm EST).