Waterworks R.W. Atlas Bridge Two Hole Deck Mounted Lavatory Faucet with Metal Lever Side Mount Handles - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
RW ATLAS
Bridge Two Hole Deck Mounted Lavatory Faucet
INSTALLATION GUIDELINES
Page 1 of 2 8.14.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS BRIDGE TWO HOLE DECK MOUNTED LAVATORY FAUCET WITH METAL LEVER SIDE
MOUNT HANDLES (STYLE# RWLS50)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Side Mounted Metal Lever Handles
Style No. RWLS50
SPECIFICATIONS:
Drain Depth Maximum: 2-1/2"
Drain Depth Minimum: 3/8"
Drain Hole Diameter: 1-3/4"
Drain Style: Push Touch (Drain Included)
Fitting Hole Diameter: 1-3/8"
Handle Spread: 8" (NOT ADJUSTABLE)
Inlet Connection Size: 1/2"
Inlet Connection Type: Male with supply nut
Maximum Deck Thickness: 1 -1/2"
Minimum Deck Thickness: 3/8"
Maximum Water Pressure: 80psi
Minimum Water Pressure: 20psi
Recommended Water Pressure: 45psi
Restricted Maximum Flow Rate: 2.2gpm
IMPORTANT:
¾ NOTE: The screws on the top of the handle
assembly are aesthetic and do not serve any
mechanical purposes and should not be removed.
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ The faucet must be onsite prior to rough-in and
allows the installer to visualize the installation and
match the 8" center spread.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty on deck fittings. Upper and lower
washers are provided.
FAUCET INSTALLATION:
¾ See Figure - 01. for Steps 1-3.
1. Remove the rubber washer, plastic washer & nut
from both of the spout assembly's threaded shanks.
Note: The inlet tube may need to be unthreaded and
removed in order to remove nut.
2. Place the spout assembly through both holes in the
deck, along with the outlet hose & inlet tube.
3. Re-install rubber washer, plastic washer and nut
from under the deck. Tighten the nut up against the
bottom of the mounting surface to secure the spout
assembly.
Figure - 01
SPOUT
ASSEMBLY
HANDLE RUBBER
WASHER
HANDLE PLASTIC
WASHER
HANDLE NUT
INLET
TUBE
AERATOR
8"