Waterworks R.W. Atlas Low Profile Three Hole Deck Mounted Lavatory Faucet with Metal Lever Handles - Manual

RW ATLAS
Low Profile Three Hole Deck Mounted Lavatory Faucet
INSTALLATION GUIDELINES
Page 1 of 4 6.26.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS LOW PROFILE THREE HOLE LAVATORY FAUCET WITH METAL WHEEL HANDLES
(STYLE# RWLS20) & METAL LEVER HANDLES (STYLE # RWLS30)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
Metal Wheel Handles
Style No. RWLS20
Metal Lever Handles
Style No. RWLS30
SPECIFICATIONS:
Drain Depth Maximum: 2-5/8"
Drain Depth Minimum: 3/8"
Drain Hole Diameter: 1-3/4"
Drain Style: Push Touch (Drain Included)
Fitting Hole Diameter: 1-3/8"
Handle Spread Maximum: 12"
Handle Spread Minimum: 8"
Inlet Connection Size: 1/2"
Inlet Connection Type: Male with supply nut
Maximum Deck Thickness: 1 -5/8"
Minimum Deck Thickness: 1/4"
Maximum Water Pressure: 80psi
Minimum Water Pressure: 20psi
Recommended Water Pressure: 45psi
Restricted Maximum Flow Rate: 2.2gpm
IMPORTANT:
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Refer to the specifications and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty on deck fittings. Upper and lower
washers are provided.
HANDLE INSTALLATION:
1. Remove the handle assembly (1 or 2) and upper
washer (3) from the side valve (6). Do not remove
the lower washer (4) and nut (5). NOTE: The screw
on the front of the handle assembly is aesthetic and
does not serve any mechanical purposes and should
not be removed.
2. Thread the nut (5) all the way down and insert the
side valve (6) into the hole from underneath the
mounting surface, then thread the handle assembly
back onto the side valve until it is fully seated.
Ensure that the washer (3) is underneath the handle
assembly.
3. Tighten the nut (5) up against the bottom of the
mounting surface to secure the handle assembly.
4. Repeat steps 1-3 to install the second side valve (6
or 18) and handle (19 or 20).
SPOUT INSTALLATION:
5. Remove the tee (16), washer (7) and mounting
hardware (13-15) from the spout (11).
6. Insert the spout into the hole on the mounting
surface making sure the o-ring (12) is underneath the
spout.
7. Re-attach the mounting hardware (13-15) and
tighten the nut (15) to the bottom of the mounting
surface to secure the spout.