Waterworks Easton Classic Two Hole Bridge Gooseneck Kitchen Faucet, Oak Lever Handles and Spray - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
EASTON CLASSIC
Two Hole Bridge Kitchen Faucet and Spray
INSTALLATION GUIDELINES
Page 1 of 2 9.16.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
EASTON TWO HOLE KITCHEN FAUCET WITH SPRAY. STYLE NOS.
EAKM31, EAKM32, EAKM33, EAKM34, & EAKM35
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
Style No. EAKM31
Metal Cross Handles
Style No. EAKM32
Metal Lever Handles
Style No.
EAKM33
White Porcelain Lever Handles
Style No. EAKM34
Black Porcelain Lever Handles
Style No. EAKM35
Oak Lever Handles
SPECIFICATIONS:
Deck Thickness: 1/4" MIN - 1-1/4" MAX
(6mm MIN - 32mm MAX)
Fitting Hole Diameter Ш1-3/8" (Ш 35mm)
Inlet Connection Size &
Type: 1/2" Male
Restricted Maximum Flow
Rate: 2.2gpm (8.32 L/min)
Spout Reach: 9-7/8" (250mm)
Spout Swivel: Yes
Water Pressure: 20 psi MIN - 80psi MAX
(1.4 Bar Min - 5.5 Bar Max)
Water Pressure
Recommended: 45 psi (3 Bar)
IMPORTANT:
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal, state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ The use of certain putty may stain stone or tile
surfaces. Upper and lower washers are provided.
SPOUT INSTALLATION:
¾ See Figure 1. for Steps 1-4.
TEE NUT
SPACER
O-RING
TEE
O-RING
NUT
RUBBER
WASHER
MOUNTING
DECK
COPPER
TUBE
RUBBER
GASKET
ESCUTCHEON
SHANK
AERATOR
HOUSING
RUBBER
WASHER
AERATOR
SPOUT
ASSEMBLY
TEE NUT
SPACER
O-RING
TEE
O-RING
NUT
RUBBER
WASHER
MOUNTING
DECK
COPPER
TUBE
RUBBER
GASKET
ESCUTCHEON
SHANK
AERATOR
HOUSING
RUBBER
WASHER
AERATOR
SPOUT
ASSEMBLY
FIGURE - 01
1. Remove the NUT & RUBBER WASHER from the
bottom of the SHANKS.