Waterworks Henry Three Hole Gooseneck Kitchen Faucet, Metal Lever Handles and Spray - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
HENRY
Three Hole Gooseneck Kitchen Faucet and Spray
INSTALLATION GUIDELINES
Page 1 of 3 10.14.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
HENRY THREE HOLE KITCHEN FAUCET WITH SPRAY. STYLE NOS.
HNKM20 & HNKM30
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
Style No. HNKM20
Metal Cross Handles
Style No. HNKM30
Metal Lever Handles
SPECIFICATIONS:
Deck Thickness: 3/8" MIN - 1-1/2" MAX
(10mm MIN - 38mm MAX)
Fitting Hole Diameter Ш1-3/8" (Ш 35mm)
Inlet Connection Size &
Type: 1/2" Male
Restricted Maximum Flow
Rate: 2.2gpm (8.32 L/min)
Spout Reach: 9-1/2" (241mm)
Spout Swivel: Yes
Water Pressure: 20 psi MIN - 80psi MAX
(1.4 Bar Min - 5.5 Bar Max)
Water Pressure
Recommended: 45 psi (3 Bar)
IMPORTANT:
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal, state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ The use of certain putty may stain stone or tile
surfaces. Upper and lower washers are provided.
SPOUT INSTALLATION:
¾ See Figure 1. for Steps 1-4.
SHANK
FILTER
SCREEN
AERATOR
REMOVAL
TOOL
DIVERTER
TEE
TEE RUBBER
WASHER
NUT
RUBBER
WASHER
MOUNTING
DECK
ESCUTCHEON
RUBBER
GASKET
AERATOR
SPOUT
ASSEMBLY
SHANK
FILTER
SCREEN
AERATOR
REMOVAL
TOOL
DIVERTER
TEE
TEE RUBBER
WASHER
NUT
RUBBER
WASHER
MOUNTING
DECK
ESCUTCHEON
RUBBER
GASKET
AERATOR
SPOUT
ASSEMBLY
FIGURE - 01
1. Remove the NUT, RUBBER WASHER & DIVERTER
TEE from the bottom of the SHANK.
2. Place the SPOUT ASSEMBLY through the hole on
the MOUNTING DECK, making sure the RUBBER
GASKET is below the ESCUTCHEON.