Waterworks Julia Three Hole High Profile Kitchen Faucet , White Porcelain Lever Handles and White Porcelain Spray - Manual

Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc. 10.06.06
These guidelines have been prepared for the professional contractor to aid in the installation of:
JULIA FOUR HOLE KITCHEN MIXER WITH SPRAY, CROSS HANDLES (JUKM18) &
LEVER HANDLES (JUKM19-K, JUKM20-K, JUKM21-K)All dimensions are based on original
specification and are subject to change and variation. Please consult your Design Associate for current
specifications.
3 1
4
"
6 1
2
"
2 1
2
"Ш
8"-12"
2 3
4
"
9 5
8
"
9 1
2
"
5 3
8
"
3 1
4
"
3 5
8
" 3 1
2
"
2 1
2
"Ш
3 1
4
"
JUKM19-K
Julia Four Hole Kitchen Mixer With Spray
JUKM18(cross handles)
JUKM19-K(metal lever handles)
JUKM20-K(white porcelain lever handles)
JUKM21-K(black porcelain lever handles-MTO)
JUKM20-K, 21-K
2 1
2
"Ø
IMPORTANT
To ensure this product is installed properly, you
must read and follow these guidelines.
The owner/user of the faucet must keep this
information for future reference.
Be sure your installation conforms to local codes.
Refer to the specification and assembly drawings
attached. Faucet is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
Inspect this product to assure you have all parts
required for proper installation.
Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
If possible, install the faucet assembly on the sink
or mounting surface before setting.
Do NOT use putty during this installation.
SIDE VALVE INSTALLATION
1. Disassemble the index assembly (1-5) as 1 unit
from the handle hub (8) by lifting the ring (1) off
of the handle.
2. Insert a bladed screw driver into the handle and
loosen the screw (6) then pull the handle off the
cartridge (11).
3. Unthread the cover (9) from the cartridge then
base escutcheon (10) from the side valve (15).
Remove 1 sealing gasket (12) as an upper seal.
Do NOT remove the other sealing gasket or
hardware (12-14).
4. Insert the side valve into the hole in the mounting
surface so at least 1" of threads are exposed.
5. Install the upper sealing gasket onto the side valve
then thread the base escutcheon(10) onto the
side valve until it contacts the mounting surface.
6. Thread the cover(11) onto the cartridge hand
tight at which point it will stop.
7. Unthread the base escutcheon until it contacts
the cover which will assure proper side valve
height.
8. Tighten the nut (14) up against the underside of
the mounting surface to secure the side valve.
9. Reinstall the handle and index assembly.
10. Repeat these steps to install the second side
valve.
SPOUT INSTALLATION
11. Remove the tee/diverter assembly (30-35) and
spout attachment hardware (29a(1) - 29c) from
the spout.
12. Insert the spout assembly (19-29a(1), 36,37)
through the spout hole of the mounting surface.
13. Place 1 rubber spout gasket (29a) then spout
washer (29b) and nut (29c) onto the spout shank
(29).
14. Tighten the nut to secure the spout to the
mounting surface.