Waterworks .25 Low Profile Three Hole Deck Mounted Lavatory Faucet with Metal Lever Handles - Manual

Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc. 04.30.07
.25 Low Profile Lavatory Faucet
These guidelines have been prepared for the professional contractor to aid in the installation of:
.25 LOW PROFLIE LAVATORY FAUCET WITH CROSS HANDLES (PTLS01-K) &
LEVER HANDLES (PTLS02-K) All dimensions are based on origin specification and are subject to
change and variation. Please consult your Design Associate for current specifications.
PTLS01-K (Cross Handles)
PTLS02-K (Lever Handles)
SIDE VALVE INSTALLATION
1. Remove the handle trim connector (3), gasket (4) and
plastic spacer (5) from the side valve (9). Do not remove
the lock nut (8), washer and lower gasket (7).
2. Determine the thickness of the mounting surface. If it is
less than 1 1
2
", slide the plastic spacer (5) onto the side valve.
If the surface is greater than 1 1
2
", do not use the spacer.
3. Insert the side valve into the hole in the mounting surface.
4. Slide the rubber gasket (4) onto the handle trim connector
(3). Thread the handle trim connector completely onto the
side valve (about 6 full turns) until it stops. If the connector
does not thread down completely, adjust the lock nut.
5. After the connector is on completely, tighten the lock nut
against the underside of the mounting surface to secure
the side valve.
6. Position the handle assembly over the valve then thread
the handle assembly (1) onto the side valve until it stops.
Hand tight is adequate; if this assembly is too tight, the
handle will bind.
7. Repeat these steps to install the second side valve.
SPOUT AND DRAIN INSTALLATION
Note: This faucet does not use a lift rod to operate the drain
stopper. Instead, it uses a simple pop-up drain that is closed
and opened by pushing down on the stopper.
8. Unthread and remove the spout mounting nut (13), metal
washer (12), and foam gasket (14) from the spout.
9. Insert the spout assembly (11) through the spout hole of
the mounting surface, reinstall the rubber and metal spout
washers then tighten the spout mounting nut to secure the
spout to the mounting surface.
10. Thread each supply hose (26) into the spout shank. Hand
tight is adequate, do NOT over tighten.
11. Connect each of the supply hoses to the adjacent side
valve (9) making sure the hoses are not pinched/kinked.
12. Remove the upper collar (18) from the pop-up drain
assembly and discard the upper gasket (19).
13. Set the upper collar in the lavatory drain opening using a
clear adhesive silicone.
2 1
2
"
3"
2 3
8
"
5 1
2
"
3 7
8
"
2 3
8
"Ш
2 1
4
"
5 1
2
"
3 7
8
"
2 1
4
" 2 1
2
"
3"
2 3
8
"Ш
3 1
8
"
IMPORTANT
To ensure this product is installed properly, you must read
and follow these guidelines.
The owner/user of the faucet must keep this information
for future reference.
Be sure your installation conforms to local codes.
Refer to the specification and assembly drawings attached.
Faucet is sold partially assembled but shown fully
disassembled for illustrative and service purposes only.
Inspect this product to assure you have all parts required
for proper installation.
Use only a strap wrench or protected/smooth-jaw wrench
on any finished surface.
If possible, install the faucet assembly on the sink or
mounting surface before setting.
Do NOT use putty during this installation.