Waterworks R.W. Atlas Two Hole Bridge High Profile Kitchen Faucet, Metal Side Mount Levers and Spray - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
RW ATLAS
Two Hole Kitchen Mixer with Spray
INSTALLATION GUIDELINES
Page 1 of 2 8.13.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS TWO HOLE KITCHEN MIXER WITH SIDE MOUNT LEVER HANDLES AND SPRAY
(STYLE # RWKM10).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Side Mounted Metal Lever Handles
Style No. RWKM10
SPECIFICATIONS:
Fitting Hole Diameter: 1-3/8"
Handle Spread: 8" [NOT ADJUSTABLE]
Inlet Connection Size: 3/8"
Inlet Connection Type: Female Straight
Maximum Deck Thickness: 1-1/2"
Minimum Deck Thickness: 1/4"
Recommended Water Pressure: 45psi
Spout Reach: 10"
Spout Swivel: Yes
IMPORTANT:
¾ NOTE: The screws on the top of the handles are
aesthetic and do not serve any mechanical purpose
and should not be removed.
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Product should be on-site prior to rough-in. This
allows the installer to visualize the installation and
verify the center spread.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty on deck fittings. Upper and lower
washers are provided.
SPOUT INSTALLATION:
¾ See Figure 1. for Steps 1-3.
1. Remove the rubber washer, plastic washer & nut
from both of the spout assembly's threaded shanks.
Note: The inlet tube may need to be unthreaded and
removed in order to remove nut.
2. Place the spout assembly through both holes in the
deck, along with the supply hoses and spray outlet
hose.
3. Re-install rubber washer, plastic washer and nut
from under the deck. Tighten the nut up against the
bottom of the mounting surface to secure the spout
assembly.
Figure - 01
SPOUT
ASSEMBLY
RUBBER
WASHER
PLASTIC
WASHER
NUT
AERATOR
HOT
SUPPLY
HOSE
COLD SUPPLY
HOSE
SPRAY OUTLET
8"
SIDE SPRAY INSTALLATION:
¾ See Figure 2. for Steps 4-10.
4. Remove the nut and rubber washer from the bottom
of the threaded tube. Unthread the retaining collar
from the top of the threaded tube and remove the
plastic sleeve.
5. Loosen the hex collar and insert the threaded tube
along with the escutcheon and hex collar into the
hole in the deck, making sure the o-ring is between
the escutcheon and the deck.
6. Re-attach the rubber washer and nut to the
threaded tube from under the deck.