Waterworks Etoile Low Profile Two Hole Wall Mounted Lavatory Faucet (Straight Spout) with Cross Handles - Manual

Etoile Wall Mounted Lavatory Faucet
December, 1999
1/00
W A T E R W O R K S
These guidelines have been prepared for the professional contractor to aid in the installation of:
ETOILE WALL MOUNTED LAVATORY FAUCET (ETLS 66)
All dimensions are based on original specifications and are subject to change and variation.
Please consult your Design Associate for current specifications.
Installation Guidelines
ETLS 66 INSTALLATION GUIDELINES
‚ Use only a protected, smooth-jawed, or strap wrench on any finished surface.
‚ Inlet connections are 1 ⁄ 2 " female NPT.
‚ Well-supported 1 ⁄
2
" nipples should be stubbed-out at the proper center spread.
‚ Be sure that the supplies are level, secure, and on proper centers.
‚ Be sure that the gaskets (provided) are used on the connections from the
valve bodies to the spout.
‚ The upper waste assembly can be set with putty.
‚ Check for leaks.
‚ After installation, unscrew and remove the aerator assembly. Carefully open
the hot and cold valves fully to flush out any debris in the supply
lines. Once the lines have been flushed, close the valves and reinstall the
aerator assembly.
‚ The spout projects 10" from wall.
‚ The unit is supplied with 1 1 ⁄ 4 " lift-and-turn drain.
‚ To service valve stem: Unscrew the index assembly to expose the screw for
the handle.The cover should be hand tight.
‚ If further assistance is required, please contact Product Support at
1-800-927-2120 (8am–7pm EST).
1
H C
7 7 ⁄
8
"
8
"
10"
2"
1 ⁄ 2 " Female NPT inlets
Supplied with 1 1 ⁄ 4 " lift-and-turn drain
All dimensions are approximate.
The center spread will vary,
and for this reason, it is strongly
recommended that rough-in be
done with product on-site.